Welcome to 3D Professor

EXCLUSIVE - DISKEEPER 2008
HD Tach Version 3.0.4.0
Going straight to the main points of the benchmark we ran the full test. As you are aware this benchmark has 3 types of test; short, long and full. The full test completely stretches the disc I/O. Average read speed in the full test increases by with Diskeeper 2007 installed by 1.2Mb/s with the actual burst speeds with nearly a complete 12Mb/s increase which is quite a lot to recover on a drive of this magnitude. With Diskeeper 2008 installed the results completely took our breath away.
Full Test with No Disk Defragmentation Software

Full Test with Diskeeper 2007 Enabled

Full Test with Diskeeper 2008 Enabled

SiSoftware Sandra XI SP4
File System with No Defragmentation Software	File System With Diskeeper® 2008

Physical Disc Test with No Defragmentation Software	Physical Disc Test with Diskeeper® 2008 Enabled

Physical disc improvement shows slight improvements of approx 3Mb/s with the Drive Index Time
Page 1 - Introduction Page 2 - Diskeeper 2008 - Product Enhancements Page 3 - Part 1, System Configuration (XP Pro SP2 32 bit mode) & Software Used Page 4 - SPECapc for 3ds Max™ 9 and SPECviewperf® 10 Page 5 - HD Tach Version 3.0.4.0 & SiSoftware Sandra XI SP4 Page 6 - Autodesk 3ds Max 9 SP2 Page 7 - Part II, System Configuration (Server 2003 SP2 32 bit mode) & Software Used Page 8 - HD Tach Version 3.0.4.0 Page 9 - SiSoftware Sandra XI SP4 Page 10 - Autodesk 3ds Max 9 SP2 Page 11 - SPECapc for 3ds Max™ 9 and SPECviewperf® 10 Page 12 - Conclusions

3D Professor Contact Details

Send mail to administrator@3DPROFESSOR.ORG with questions or comments about this web site.
© All brands and names are the property of their respective owners.

Prices & Specifications are subject to changes. Errors & Omissions Excepted.
All content on this site is Copyright © 1999 - Ongoing www.3dprofessor.org All Rights Reserved.
Use of content without written agreement is forbidden. This site is covered by UK Law and International Treaties.